The showroom doors open onto the lit atrium
A red horizontal expansion vessel in a glass vitrine
A brushed steel pressure tank on saddles in a vitrine
A red vertical expansion vessel on a lit plinth
A tall storage tank with an internal coil heat exchanger
A finned heat exchanger with manifold in a vitrine
A stainless steel chimney flue section in a vitrine
A weathered compressor shell on a lit plinth
A stainless steel dishwasher tub in a glass vitrine
A stainless steel enclosure in a vitrine, protective film still applied
The LEAS showroom entrance, doors closed again

AR Showroom

Everything we weld, standing in your room.

00 Entrance

The showroom

Step inside.

Nine components that come off LEAS welding lines, one to a plinth. Walk the room, then put any of them on your own floor at true size — straight from the browser, no app to install.

  • Since 1973
  • Padova, Italy
  • 9 pieces in AR

01 09

Expansion vessels

Expansion vessel.

Two deep-drawn shells closed by a circumferential wire weld — the seam that has to hold pressure and still look right. Two welding units work the joint at the same time.

  • Circumferential wire weld
  • Two units, one pass
  • +30% output

02 09

Pressure tanks

Pressure tank.

Shell, dished ends, flange and saddles located and joined inside one automated cell. The welding programme is written around the structure, not the other way round.

  • MIG/MAG + resistance
  • Saddle-mounted
  • Industry 4.0 traced

03 09

Expansion vessels

Vertical vessel.

The same joint on a different geometry. The cell re-tools for a new diameter in under two hours, so a production run never waits on a new machine.

  • < 2 h changeover
  • Ø 300–800 mm
  • Leak-tested inline

04 09

Storage tanks

Storage tank.

A coil heat exchanger welded inside the shell before it is closed — hundreds of joints nobody can reach once the tank is sealed. The robot gets one attempt at each of them.

  • Internal coil
  • Robotic cell
  • 1600 mm class

05 09

Heat exchangers

Heat exchanger.

Fin pack and manifold joined by resistance and arc welding, with the robot built into the assembly line rather than bolted on beside it.

  • Resistance + arc
  • Robot-integrated
  • Fin pack assembly

06 09

Burners & flues

Chimney flue.

Thin stainless wall, tight radius, no distortion allowed. Here the automation is adapted to the geometry of the component — the component is never adapted to the machine.

  • Thin-wall stainless
  • Laser + TIG
  • Geometry-led tooling

07 09

Chillers

Compressor shell.

Housings for chiller units, welded and assembled by industrial robots. Repeatability counts for more than speed here: every shell has to seal exactly like the last one.

  • Robotic welding
  • Chiller units
  • Sealed housing

08 09

Home appliances

Dishwasher tub.

Stainless sheet folded and seam-welded into a watertight cavity. Appliance work is where cycle time is counted in seconds and the weld still has to disappear.

  • Seam welding
  • Watertight cavity
  • Appliance line

09 09

HVAC & refrigeration

Stainless enclosure.

Folded stainless panels seam-welded onto corner posts into a cabinet that stays square under load. It leaves the cell exactly like this, protective film still on.

  • Seam + spot welding
  • Folded stainless
  • Film still on

End of the visit

The doors close.
The line doesn’t.

Every piece you just walked past leaves a LEAS welding cell. This is what those cells do.